![]() ![]() Compared to the first generation, they offer easier and clearer programming with the transmitter and truly simple and lightning fast setup with the new LED programming card RAY G2 (sold separately). I tried your program but i got nothing out of it.Programmable microprocessor controllers of the new generation (G2) for brushless, sensorless? Motors designed with the use of state-of-the-art semiconductor technology. I have adapted a version of the servo sweep program with pretty crappy results but i got it turning. Im also trying to controll a motor, but Im using a Digital Speed Controll made by Hitec, it is an SP 1801n: not gunna hold that thing in my hand ever again, it wanted to rip free. ![]() filled it with golf balls, mounted the motor with a couple rubber dampeners and i have some rubber feet on the bottom. I just finished making a motor mount with a 25pack cd storage container. Thnx for the responses so far mem, it has helped a lot, makes me happy that i bought the arduino due to the help i get on the forum and website. ![]() which i guess means it doesn't arm at any of those values. i did the same with "int pos = 180" with the same results, same with 90. I then tried just going at "int pos = 0" and i got 3 beeps and a few jiggles but nothing happened. I ran the servo sweep sketch and it took a while but then the motor kicked in and sped up (wow its fast, was holding it in my hand), then it slowed down to a stop (was too busy trying to turn it off to know for sure if its speed tapered to a stop) and i turned it off after it repeated the process a second time. Here's an update as i mess around with it more and maybe i'll get some more tips/info as i am in the process of trying stuff out. Safe power arming program ensures motor will not run accidentally after turn on.Low voltage auto setting based on battery.Int val = 0 //variable to store PWM value Will this code work (assuming i don’t have a problem with arming)?: is a delay necessary (if no delay is used, will it just automatically delay the 2ms period of the PWM signal?)? is a minimum throttle signal necessary previous to this code or will the fact that this code ramps up make that unecessary? int ESCpin = 11 // ESC signal wire connected to pin 11 on arduino does myservo.write work like analogWrite except that it is pre-tweaked for degrees?) Where does pulse width come into play in the servo examples? (i.e. Unfortunatelyi don’t have instructions for the controller, the only info i have for it is at the bottom of this post. Thnx for the responses but i still have questions (i will solder everything tomorrow and then try to control the motor). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |